Install Manual

18
EN
This Wallbox charger can be used with any
Battery or Plug-In Hybrid Electric Vehicle
(BEV/PHEV) that is compliant with SAE J1772
(Including Teslas using the Tesla provided
adapter)
With your charger powered, connect the EV
connector to your vehicle’s charge port/input.
Connecting your charger will automatically
initiate the charging process.
If you are using the myWallbox app and have
either locked your charger or set a charging
schedule, the charging process will not start
until you use myWallbox to unlock your
charger or until the scheduled charging time.
If the LED halo is red (error notification), it
means your charger has detected a safety
issue with your electrical connection or
vehicle.
Note that some errors will initiate an
automatic reset after 15 seconds if the
detected fault is resolved.
If the error does not automatically reset,
unplug the EV connector from the vehicle and
cycle through a power o/power on sequence
by switching o the circuit at the circuit
breaker and then switching it back on.
If the error persists, contact Wallbox customer
service for additional instructions on how to
resolve the error.
Compatibility
Charging
Troubleshooting
40
AMPS
CONNECTED
Operating