Install Manual

17
EN
If you have installed a NEMA plug-in model,
insert the NEMA plug in the receptacle.
For all models, once all electrical connections
have been safely made, switch on the power to
the circuit from the circuit breaker.
The charger LED ring should light up in a steady
green. If the LEDs are not lighting, power o the
circuit at the circuit breaker and contact your
electrician to ensure proper electrical installation.
Powering on
Guide to LEDs
Registering and
Connecting your charger
Download the myWallbox app to your
smartphone or tablet, log in and follow the
on-screen instructions to create an account
and register your charger. You will need to
verify your account with a valid email address.
Once you have created your account, launch
the app and follow the on-screen instructions
for connecting to and registering your charger.
To connect your charger, you will need to
enter the serial number (SN) and unique
identification number (UID). This information
may be found on your charger label.
Green: Ready
Light Blue: Connected to EV, ready for charge
Dark Blue (pulsing): Charging
Yellow: Locked
Red: Error (see troubleshooting section on page
18)
Operating
NOTE: Once you have powered on the connected circuit, your charger will be ready to charge your EV. To
fully access your charger functions and control your charger remotely, however, you will need to download the
myWallbox app to a mobile device (smartphone or tablet) and register your charger following the directions below
If you have any diiculty connecting your
charger to your myWallbox app, please refer
to the “Help & Support” link on the app under
your user profile. If you have trouble with the
app, please go to support.wallbox.com