Operating Guide

C e r a m i c C o o k t o p

W a l l a s S t o v e s

USER GUIDE

8 8 D U M A R I N E S T O V E

88 DU

PI THERMO CONTROL PANEL

88 DU installation, operation

and service instructions

88 DU marine stove

product information

PAGE 1
USER GUIDE 88 DU MARINE STOVE 88 DU Ceramic Cooktop PI THERMO CONTROL PANEL Wallas 88 DU installation, operation and service instructions Stoves 88 DU marine stove product information
PAGE 2
OPERATION GUIDE PI THERMO CONTROL PANEL 88 DU Marine Stove Please Refer to Manual for Full Operation and Maintenance Instructions at wallas.com IGNITION Press the Power Button for 3 seconds until the yellow power light will come on. When you release the button, the yellow heating light will appear. 1 3 2 7 I Red combustion light will light up when the burner flame has been ignited and the combustion has stabilised (approx. in 5 min). Stove will be fully operational about 10 min later.
PAGE 3
PANEL LIGHTS I Heating on I Heating on in High Altitude Mode Combustion has begun/is running Cooldown/Flameout I Low voltage (usually about 15 sec after initiating start) I Overheat Reminder indicating there was a fault after fault code flashed for 5 min 30 s Locked for security The device locks itself after two unsuccessful starts I Reach Out to a Wallas Professional for the Following: I 2s I 2s I www.wallas.