Specifications

10.4.4 Adjustment of blade tracking
Below are the main course for incorrect balde tracking *
Short ball
(1) The weights of blades are unequal.
linka
g
es o
f
main baldes
(2) The gravity center distribution of blades is unequal.
(3) The lengths of ball linkages of two blades are set improperly.
(4) When blades are too loose, blades shake due to gap,
or main blade connectors distort.
When there exists tracking baldes, please shorten the
length of the ball ge of the linkage located In the of the
higher blade, or prolong the length of the ball ball linkage
located in the of the lower blade
If the main blades are normal at low speed but abnormal at high speed, or normal at high speed but abnormal
at low speed, please check whether or not the main blade connectors are loose or distorted. If the main blade
connectors are loose, please tighten their screws; if the main blade connectors distort, please change new
one. The bad blade tracking can be removed just by repeatedly fine adjustments.
Step 1: disconnect the power Step 2: turn off the Step 3: Remove the battery pack.
cable of helicopter. transmitter.
18
10
Steps
of flight
11
Flight over