Specifications

10.1 Installation of battery

Install the battery pack into the battery compartment in the

direction of the arrow.

Steps

of flight

Battery

location

Diagram of battery installation.

10.2 Turn on the power

10.2.1 Turn on the power

1. Install the battery pack in the battery 2. Turn on the power of transmitter.

compartment.

3. Pull down the throttle stick and throttle trim 4. Connect the power cable of the helicopte

of transmitter to the lowest position, and then and wait to receive the signal from the

move the elevator trim, aileron trim, and rudder

transmitter. The helicopter should be

trim at the neutral positions, respectively.

placed on flat ground or surface during

code paring (binding). Do not move the

transmitter sticks or the helicopter until

binding has completed.

10.2.2 Matters needing attention

(1) Please strictly follow the sequence of "power on the transmitter first, then connect the battery". Turn on the

transmitter, then connect the battery with receiver within 10 seconds, the red light on receiver begins flash. The red

light will get a solid light 1-3 seconds, after the transmitter finishes pairing with receiver, the red light will flash

again. If the red light get a solid light and a mechanical BEEP sound can be heard from the servo, it means the

receiver have received the signal from the transmitter and their codes match successfully.

(2) If failed to connect the power cable of helicopter in 10 seconds after transmitter is turned on, please turn off

the transmitter and repeat the step (1).