Quick Start Guide

Step 11
P.10
N
Ø15*10mm
06
Ø3,0*20mm
06
N
To adjust the drawer front position:
Loosen the screw (part C or M) you used to
install the drawer runner (either parts H
or I) in step 2, to the side panel
(parts 02 or 03), depending on the side
(left or right), or division ( part 16) as shown.
With the screw (part C or M) loosened, you
can make the necessary slight
adjustments (up or down) to the drawer
runner to achieve the proper drawer
alignment.
Once the drawer alignment is square, secure
the position of the drawer runners (parts H &
I) to the side panels (parts 02 & 03) by re-
tightening the part M screw and adding the
part R screw + N as shown.
M
C or M
R
Once the drawer alignment is square, secure
the position of the drawer runners (parts H &
I) to the division panel (part 16) by re-
tightening the part C screw and adding the
part B screw as shown.
C
B
Parts 02 or 03
Part 16
B
Ø3,0*14mm
06
R