Installation Guide

X
30mm
(1.2 )"
ø 2.5mm
(ø 3/32")
Step 1
Option A
Option B
35mm
(1.4 )"
ø 6mm
(ø 1/4")
3
Step 2
Wood Stud
Concrete/Brick Wall
Drill holes at the marked positions. Place the Bracket
A
over the marked screw
locations. Insert Screws
B
into the mounting holes and tighten using a screwdriver.
Drill holes at the marked positions. Insert the Anchors C into the mounting holes. Place
the Bracket A over the marked screw locations. Insert Screws B into the mounting holes
and tighten using a screwdriver.
Guide the Dot 2nd Gen to the bracket. Tie the power cord with Velcro Strap
D if needed.
C
A
D
B
B
A