User Manual

4 CONNECTORS & CONTROLS
4 Connectors & Controls
No Id Description
1 Sym CV Input Used to modulate the Symmetry of the wave-
form
2 Speed CV Input Used to modulate the Speed of the waveform
3 Signal Input For positive gate signals
4, 7, 10 Outputs Waveform outputs
5 Gate Input A positive gate signal will start the envelope
and when turning zero release it. If the gate
input isn’t patched, then the gate signal from
the Euro Rack bus is used, but only if the trig-
ger input isn’t patched.
6 Trigger Input For alternative trigger Signal. When the Trig-
ger input is used instead of the Gate input,
the envelope is triggered by a positive volt-
age impulse at the trigger input and releases
automatically after the final decay stage.
8 Inverse Output The inverse output gives the same envelope
but with negative voltages. This is useful
for modulating filter cut-off frequencies in the
falling direction.
9 Signal Input For positive gate signals. If the input isn’t
patched, then the gate signal from the Euro-
rack bus is used.
11 Symmetry Knob Controls the symmetry of the waveform
12 Speed knob Controls the speed of the waveform up to
25Hz
13 13 Square/Lin Switch Controls if the output consists of linear seg-
ments for sawtooth and triangle waveforms,
or in rectangular shape in which case the
symmetry controls the pulse width. Square
is mostly useful in LFO mode.
14 Trig, Gate, LFO Switch Activates the different modulation modes
15 Attack Knob Used for controlling the attack time
5