Instruction Manual

14
Operating Manual Light Control „PULSE HFMD / PULSE PIR - Vers. IV“
ENG
List of the parameterising functions
Note: The functions written in blue are not active in all versions. Please note the explanations of the func-
tions on the following pages.
Fig. 3
LED 1 2 3 4 5 6
Fig. 6
Key I
Light
bar
Key II
The following functions can be selected:
The bold-printed values are the in-factory defaults
Level Function Light bar (Fig. 6) Designation
1 Funct. 1.1: LED 1 (dark green) Light bar ON/OFF
1 Funct. 1.2: LED 2 (light green) External switching ON/OFF
1 Funct. 1.3: LED 3 (yellow) Burn-In function ON/OFF
1 Funct. 1.4: LED 4 (orange) Write protection ON/OFF
1 Funct. 1.5: LED 5 (light red) Light control ON/OFF
1 Funct. 1.6: LED 6 (dark red) Presence control ON/OFF
1 Funct. 1.7: LED 6+5 Demo mode ON/OFF
2 Funct. 2.1: LED 1 (dark green) Sensitivity high ON/OFF
2 Funct. 2.2: LED 2 (light green) Automatic switch-on ON/OFF
2 Funct. 2.3: LED 3 (yellow) Special function ON/OFF
2 Funct. 2.4: LED 4 (orange) Sensor LED ON/OFF
2 Funct. 2.5: LED 5 (light red) Continuous mode ON/OFF
2 Funct. 2.6: LED 6 (dark red) Parameter setting protection ON/OFF
2 Funct. 2.7: LEDs 6+5 Special function ON/OFF
3 Funct. 3.1 - 3.6: LEDs 1-6 Follow-up time 5, 10, 15,20, 25, 30 min
4 Funct. 4.1 - 4.6: LEDs 1-6 Range 10, 20, 40 ,60, 80, 100 %