Instruction manual

79
Current mA
Displays a live reading of the mA output of the transmitter.
Product Level
Displays the live calculated process value, using the existing 4 mA = , 20 mA = and
Dye/Product Ratio settings.
New Value
Enter the desired new reading for the ppb of fluorescent dye.
Dye/Product Ratio
The Dye-to-Product ratio is the ratio of the fluorescent dye in ppb to the active ingredient
in the chemical product in ppm. Type the ratio (given to you by your chemical supplier).
Click Continue.
At the end of the calibration, the display will tell you if the calibration was successful or if
the calibration failed. If successful, click Close to resume control. If failed, refer to Section
8 for troubleshooting help.
Reset Defaults
If for any reason you want to go back to factory default settings for the calibration coefficients,
click on the Reset Defaults button. You will be asked to verify that you want to change the
calibration. Click Yes to continue. Another window will popup to tell you that the calibration was
successful.
6.12 Flow Meter (Digital) Input Menu
All flow meters connected to digital inputs will be configured in this menu. Each meter will have a
separate section. The sections available for a contact meter will differ than those for a paddlewheel
meter.
Volume Units
Click on the radio button to select volume in units of Gallons, Liters or Cubic Meters. If you
change the units in this screen, changes will not occur on the page until the “Submit” button is
pressed.
Custom Name
Type in the text box a name to describe the flow meter.
Total/Reset Total
The Total displays the volume of solution to pass the flow meter since the last time the totalizer
was reset.
If you want to reset the total, click on the “Reset Total” button.
Last Total Reset
Displays the date and time that the totalizer was last reset.
Rate (only appears if the water meter type is selected as ‘Paddlewheel’)
Displays the current water flow rate through the water meter.