Instruction manual

147
Import UCF
Once the file name is displayed in the Browse text box, click the Import UCF button to transfer the
file to the WebMasterONE.
6.49 Notepad
The configuration Notepad gives you a place to make notes regarding any changes that you have
made to the set points, to document calibrations, system upsets or anything else that you want to
note. Simply type your message into the text box.
6.50 Access Codes
There are three levels of access code protection. If the Master password is used in the
WebMasterONE Authentication page, then any set point can be changed. If the Calibration Level
password is used in the Authentication page, then sensor calibrations will be allowed, but other
changes will not. If the Read Only password is used the user will be able to look at any page, but
will not be allowed to make any changes.
In order to change the access code for each level of access, type the present password into the text
box, then type the new password in the text box below. Type the new password again in the lowest
text box to verify that the new password has been correctly entered.
The default user name is "webmaster" and the default passwords are "2001" for full access, "2002"
for calibration only and "2003" for read only. These defaults can and should be changed to assure
security.
Change User Log-in Name
You may also change the user name for logging into the WebMasterONE. Type the new user
name into the text box.
Download Access Log
Click the link to View Log File. The Modem Access Log will tell you when the controller was
accessed. It will show you the date and time of access, the method of access, the user name used,
the IP address of the computer used for access, and the level of access code used (or that the
attempt failed).
A window will open to ask if you would like to open the file or save it to disc. Select the method
you would like to use. The file is a basic text file with a .log extension that may be opened in any
word processing program (Word, Notepad, etc.).”
6.51 Software Upgrades (only appears if a newer revision of software is available)
Whenever you connect to the WebMasterONE via an Internet connection, it will check to see if
any software upgrades are available. If there are, then the Software Upgrade page link will appear.
Note that this can only occur if the controller is connected to the Internet, either through a modem
or an Ethernet card.
If there is a newer version of software that you would like to load into your controller, then you
can upgrade to the latest revision.
Click on the link “More Info on Software Upgrade” to see what features have been added.
Click on the link “Start Software Upgrade” in order to download the new version to the controller.