Instruction manual

134
Last Config Date & Time
This line displays the last time that a Configuration Packet was attempted to be sent. It will show
“OK” if it was successful.
Last Data Date & Time
This line displays the last time that a Data Packet was attempted to be sent. It will show “OK” if it
was successful.
Log
Click the Download Log link to download a CSV file that may be opened in Excel, that details the
date and time of each packet sent and if it was successful or not.
6.42 System Status Auto-Reporting
The system status auto report is an email in html format that is a snapshot of current conditions,
identical to what is displayed on the System Summary web page.
System Status Reporting
Click the appropriate radio button to select whether the report should be sent by email (Enable) or
not (Disable).
Auto Report Log
Click the link to View Log File. The Auto Report Log will tell you the status of any report emails
that may have been sent. It will show you the date and time of the report, the type of report, the
method used to send it, whether it was successful at sending the message or not, and the reason for
a failure if applicable.
A window will open to ask if you would like to open the file or save it to disc. Select the method
you would like to use. The file is a basic text file with a .log extension that may be opened in any
word processing program (Word, Notepad, etc.).
Status
This menu is informational only, telling you when the next report is due to be sent.
Reporting Mode
Click the appropriate radio button to select an Hourly, 12 Hours, Daily, Weekly, Biweekly, or
Monthly report frequency. Type the time of day for receiving the report in the text boxes, and use
the pull down menus to select the desired day, and to select AM or PM.
Important: If this unit is part of a network of controllers, you must stagger the reports from each
controller in the network to occur at least an hour apart. Failure to do this could result in lost
reports!
Report Testing
Click the Test Reporting button to see if the report will be sent correctly. The email address
entered in the Communications page will be used. If you haven’t already entered this information,
go the Communications page and do so before trying a test report.