Instruction manual

133
System Conductivity
The system conductivity reading from the selected conductivity sensor is displayed here.
Makeup Conductivity
The conductivity reading from the selected makeup water conductivity sensor is displayed here. If
the sensor is Not Used, a text box will allow manual entry of the makeup conductivity.
System Temperature
The system temperature reading from the selected conductivity sensor is displayed here. If the
sensor is Not Used, a text box will allow manual entry of the temperature.
Calcium Hardness (CaCO
3
)
The actual wet test data for calcium hardness in ppm should be typed in this text box.
Total Alkalinity (CaCO
3
)
The actual wet test data for total alkalinity in ppm should be typed in this text box.
Assign pH Input
Click on the arrow of the pull down menu to select the sensor input that is used for the pH. If there
is no pH sensor installed, and it is necessary to manually enter the pH, select Not Used.
pH
The pH reading from the selected sensor is displayed here. If the sensor is Not Used, a text box
will allow manual entry of the pH.
6.41 VTouch Config
(only appears if a VTouch activation is enabled from the Communications menu)
This menu is used to select the data that will be sent to and displayed on the VTouch web site.
There is a list of all parameters available, with “Yes” and “No” radio buttons to select under a
column called “Send to VTouch”. Select Yes for any parameter that should be displayed on the
VTouch site.
When the Submit button is clicked, your changes will be saved, and a new VTouch Configuration
packet will be sent to VTouch containing the names, units of measure, and the latest data for each
parameter.
VTouch Communications Settings
This section is used to adjust the VTouch data update settings.
Enable Service
Use the pulldown to enable or disable the data updates.
Data Refresh Rate
Enter the number of minutes between data updates. In VCell activations, the minimum number is
more limited.