Instruction manual

6
Sensor Input Menu – if Chlorine or Chlorine Dioxide
Calibration Reminder 0-365 days
Alarm Limits 0 to 10 mg/l
Alarm Dead Band 0 to 10 mg/l
Deviation from Primary Sensor 0.01 to 10 mg/l
Damping 0 to 60 seconds
Flowmeter Input Menu – Analog Input Type
Flow Rate at 4 mA 0 to 1000 (units of measure defined by user)
Flow Rate at 20 mA 0 to 1000 (units of measure defined by user)
Level Input Menu – Analog Input Type
Empty mA 0 to 20 mA
Full mA 0 to 20 mA
Full volume 0 to 10,000 (units defined by user)
Low Level Alarm Limit 0.001 to 10,000 (units defined by user)
Generic 4-20 mA Input Menu
Parameter = 4 mA -10,000 to 10,000 (units defined by user)
Parameter = 20 mA -10,000 to 10,000 (units defined by user)
Low Alarm Limit -100,000,000 to 100,000,000 (units defined by user)
High Alarm Limit -100,000,000 to 100,000,000 (units defined by user)
Flowmeter Input Menu – Digital Input Type
Volume per Contact 0 to 1000 (units of measure defined by user)
K Factor 0.001 to 20,000 (Pulses per Gallon or Liter)
Total Alarm Limit 0 = no limit, otherwise >0
Rate High Alarm >0
Rate Low Alarm >0
Feed Verification Input Menu
Alarm Time 0.1 to 10 minutes
Pump Volume per Stroke 0.000 to 100 (units of measure defined by user)
Counter Input Menu
One Count = >0
Total Alarm Limit 0 =no limit, otherwise >0
Rate High Alarm >0
Rate Low Alarm >0
Relay Output Menu – On/Off Set Point
Set Point Full scale range of the input parameter
Dead Band Full scale range of the input parameter
Output Time Limit 0 = ∞, 1 to 1440 minutes
Hand Time Limit 1 to 1440 minutes
Time Period 0 to 1440 minutes (0 to disable PTSP mode)
Percent of Period to Feed 0.1 to 100%