Instruction manual

6.32 Configuration File Menu

If many of your cooling tower applications are nearly identical, you can save a lot of time in the

set up by downloading a typical configuration file to your hard drive, and later uploading the

configuration file to another controller.

Export UCF

In order to transfer the User Configuration File (UCF) from the WebMaster to your computer,

click the Export UCF link. You will be presented with the standard Windows dialog box to

download a file. Click the radio button to Save this file to Disk, then click OK. Select the location

where you want the file to be saved, change the name of the file if desired, then click Save. The

file is only around 14KB, so it should be transferred relatively quickly. Click Close to close the

dialog box.

The exact sequence of events and wording within the dialog box will vary depending upon the

operating system (Windows 95, 98, NT, 2000, etc.) on your PC.

Browse

In order to transfer a previously saved UCF from your computer to this WebMaster, first click the

Browse button to locate the file on your computer. A “Choose File” dialog box will open. Click on

the correct file, then click Open.

Import UCF

Once the file name is displayed in the Browse text box, click the Import UCF button to transfer the

file to the WebMaster.

6.33 Notepad

The configuration Notepad gives you a place to make notes regarding any changes that you have

made to the set points, to document calibrations, system upsets or anything else that you want to

note. Simply type your message into the text box.

6.34 Access Code Menu

There are three levels of access code protection. If the Master password is used in the Webmaster

Authentication page, then any set point can be changed. If the Calibration Level password is used

in the Authentication page, then sensor calibrations will be allowed, but other changes will not. If

the Read Only password is used the user will be able to look at any page, but will not be allowed to

make any changes.

In order to change the access code for each level of access, type the present password into the text

box, then type the new password in the text box below. Type the new password again in the lowest

text box to verify that the new password has been correctly entered.

The default user name is "webmaster" and the default passwords are "2001" for full access, "2002"

for calibration only and "2003" for read only. These defaults can and should be changed to assure

security.

Change User Log-in Name

You may also change the user name for logging into the WebMaster. Type the new user name

into the text box.