Instruction manual

5
2.4 Variables and their Limits
All menus shown may not be available. The menus that appear on your controller will vary with
options installed and programmed.
Conductivity Input Menu
Calibration Reminder 0 – 365 days
ppm Conversion Factor 0.5 – 1.0
Interval between Samples 1 – 1440 minutes (future feature)
Duration of Sample 1 – 30 minutes (future feature)
First Sampling Stage 12:00 AM – 11:59 PM (future feature)
Damping 12 sec – 48 sec
Low Alarm Limit 0 to 10,000 (units defined by user)
High Alarm Limit 0 to 30,000 (units defined by user)
Temperature Input Menu
Low Alarm Limit 0 – 158 degrees
High Alarm Limit 0 – 158 degrees
pH Input Menu
Calibration Reminder 0-365 days
High Alarm Limit 0 to 16
Low Alarm Limit -2 to 14
ORP Input Menu
Calibration Reminder 0-365 days
High Alarm Limit -1400 to 1400
Low Alarm Limit -1400 to 1400
Water Meter Input Menu
Volume per Contact 0 to 1000 (units of measure defined by user)
K Factor 0.001 to 20,000 (Pulses per Gallon or Liter)
Flow Rate at 4 mA 0 to 1000 (units of measure defined by user)
Flow Rate at 20 mA 0 to 1000 (units of measure defined by user)
Level Input Menu
Empty mA 0 to 20 mA
Full mA 0 to 20 mA
Full volume 0 to 10,000 (units defined by user)
Low Level Alarm Limit 0.001 to 10,000 (units defined by user)
Corrosion Menu
Corrosion Rate = 4 mA 0 to 10 mils/year
Corrosion Rate = 20 mA 0 to 10 mils/year
High Alarm Limit 0 to 10 mils/year