Instruction manual

45
Message Explanation
Off Line The controller is not connected.
Dialing xxx-xxxx The controller is dialing out to the ISP.
No Dial Tone The controller can not dial out due to phone line
or modem problems.
No phone number There is nothing entered in the ISP Phone No.
field.
Connecting to ISP The controller is successfully negotiating a
connection with the ISP.
On Line The controller is now on the Internet.
Checking for Upgrade The controller is communicating with our server
to see if a software upgrade is available.
Connection Timeout in The Internet connection process is complete. The number of
xxxxx sec seconds displayed depends upon the value entered in the Dialup
Connection Lifetime text box described below.
The second line is the Dial up Dynamic IP Address. This is informational, and tells you the last
IP assigned to the WebMaster by its ISP the last time it connected. When the manual ISP Dial up
process is successful, this number should change.
The third line is the date and time of the last successful connection with the ISP.
The bottom line will display “Dial ISP”, “Log Off” and “Cancel”.
Pressing the Enter key while the cursor is on “Dial ISP” will make another attempt to dial the ISP.
Pressing the Enter key while the cursor is on “Log Off” will disconnect the WebMaster from the
ISP. It is VERY IMPORTANT that you log off, or the controller will keep the connection on the
Internet until the connection times out. It is possible that this programmable maximum connection
time could be set for infinity, which could be expensive!
Pressing the Enter key while the cursor is on “Cancel” will stop the WebMaster from attempting
the Dial up process.
Ethernet IP Address
When a controller is attached to a network, your IT Administrator needs to assign it an Ethernet IP
address. When you want to communicate with the controller from your PC on the network, you go
to your Browser and type in the controller’s address.
Ethernet Subnet Mask
When a controller is attached to a network, your IT Administrator must also assign the IP
Subnet Mask. Enter this number here.
Ethernet Gateway
When a controller is attached to a network, your IT Administrator must also assign the Gateway.
Enter this number here.