Brochure

CALL [phone] · www.wal-rich.com · FAX [phone]
WAL-RICH CORPORATION • UNDERGROUND GAS PRODUCTS 2014
2
Continental Risers and Fittings for Underground PE Gas have been
sold in the gas, plumbing, and propane markets since 1990.
Con-Stab® fittings are IAPMO, CSA, & ICC approved.
What is “Anodeless”?What is Continental’s “ID-Seal”?
From NFPA 54 Section 3.3.5
“An anodeless riser is an
assembly of steel-cased plastic
pipe used to make the transition
between plastic piping under-
ground and metal piping
aboveground.”
Plastic Pipe runs inside
the riser.
Corrosion-resistant
fusion-bonded
epoxy coating
(O-RING)
Always Match Pipe Size & SDR!
W-R Size Wall (CTS) or SDR
W-R Size Wall (CTS) or SDR
2886036 1/2” CTS .090
2886004 3/4” IPS SDR-11
2886008 1” IPS SDR-11
2886040 1” CTS .099/.101
2886012 1 1/4” IPS SDR-10
2886013 1 1/4” IPS SDR-11
2886016 1 1/2” IPS SDR-11
2886020 2” IPS SDR-11
2886002 3/4” IPS SDR-11
2886006 1” IPS SDR-11
2886030 1” CTS .099/.101
2886010 1 1/4” IPS SDR-10
2886011 1 1/4” IPS SDR-11
2886014 1 1/2” IPS SDR-11
2886018 2” IPS SDR-11
2886070 3” IPS SDR-11.5
- Fusion-bonded epoxy coating
- Anodeless and corrosion
resistant
- Plain PE end can be used with
compression & “stab” fittings
You must use a
Continental Chamfer
Tool
on a Continental
Fitting!
Con-Stab®’s patented “ID-Seal” is formed on the
INSIDE of the pipe--where the surface is the smoothest.
Therefore you must chamfer the INSIDE of
your pipe with a Continental® Chamfer tool.
- Fusion-bonded epoxy coating
- Anodeless and corrosion
resistant
- Patented “ID-Seal” fitting
(inside chamfer)
CON-STAB® ANODELESS
METER RISERS
(WITH FITTING)
Always
Match
Pipe Size
& SDR
POLY-END
ANODELESS METER RISERS
2886070