Submittal Sheet

Design Features:
- For underground PE pipe (ASTM D 2513) only
- Yellow Medium Density Polyethylene - PE2406
- Corrosion Resistant Epoxy Coating
- Made in USA
Operating Specifications:
Temperature: -20° to 140° F
Pressure: 100 psi
WAL-RICH CORPORATION • SPECIFICATION PAGE
CALL [phone] · www.wal-rich.com · FAX [phone]
Poly-End Male Adapters
Job Name: ____________________________________________
Job Location: ____________________________________________
Contractor: ____________________________________________
Engineer: ____________________________________________
Approval: ____________________________________________
WR# Size Wall Steel Overall Weight Required
NFPA 58, LP-Gas Code NFPA 54, National Fuel Gas Code
ICC – International Plumbing Code IAPMO – Uniform Plumbing Code
Approved by the Commonwealth of Massachusetts
D.O.T., Title 49 of the Code of Federal Regulations, Part 192.283 (b)
ASME B31.8-1995 “Gas Transmission and Distribution Piping Systems”
ASTM D 2513 “Standard Specification for Thermoplastic Gas Pressure Pipe, Tubing and Fittings”
2885050 3/4” IPS SDR-11 6” 18-3/4” .843 2888014
2885052 1” IPS SDR-11 6” 18-3/4” 1.18 2888016
2885070 1” CTS .099/.101 Wall 6” 18-3/4” 1.05 2888022
2885054 1-1/4” IPS SDR-10 6” 18-3/4” 1.70 2888006
2885055 1-1/4” IPS SDR-11 6” 18-3/4” 1.73 2888007
2885056 1-1/2” IPS SDR-11 6” 18-3/4” 2.72 2888008
2885058 2” IPS SDR-11 6” 18-3/4” 4.24 2888010
Thickness Length Length (lbs.) Chamfer Tool
6”
18-3/4”
Medium density yellow
polyethylene PE2406
Corrosion Resistant
Fusion-Bonded Epoxy
Coated Steel
You must use a
Continental Chamfer Tool
on a Continental Fitting
Always
Match
Pipe Size
& SDR