Instruction Manual

WARRANTY INFORMATION: WARRANTY FOR REPAIR OR REPLACEMENT ONLY.
DO NOT RETURN TO PURCHASING LOCATION.
Warranty/Parts assistance contact: 800-433-0320
WAL-BOARD TOOLS | www.walboardtools.com | Marshalltown, IA USA | 800-888-0127
U.S. Patent No. 7,617,995
WARNING: Cancer & Reproductive Harm - www.P65Warnings.ca.gov.
WS3638
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
Material will not
properly atomize or
shoot out of the gun.
1. Material is not properly
mixed or thinned.
2. The compressor does
not have enough volume
(CFM) to operate the
TEXTURE-PRO® 200.
1. The texture material needs to be thinned to the consistency of thick
paint.
2. The TEXTURE-PRO® 200 requires a compressor able to produce a
minimum of 2.4 CFM @ 90 PSI or 5.3 CFM @ 40 PSI to operate.
The mud (liquid)
separates from the
Styrofoam while
shooting ceiling
acoustic.
1. Incorrect product being
used.
2. Hopper neck is clogged.
1. Insure that the material purchased is for use with hopper guns and
mix the material per the manufacturer’s instructions use with hopper
guns.
2. While spraying continue to hold the trigger back and place your finger
over the front of the material orifice. This will assist in unclogging the
hopper neck and mixing the material.
Material is being blown
around after reaching
the wall or ceiling
1. The air pressure is set
too high
2. You are too close to the
surface being textured.
1. See the texture table for proper settings. If you are using a tank-type
compressor regulate the air through the compressor.
2. You should be 3 to 4 feet from walls. For ceilings, you should be 18"
below with the hopper angled upward at 30-50.