WWST Sensor Installation Guide FCC ID: 2AUGB-N001 IC : 25402-N001
WWST Sensor At a Glance STEP 1 Attaching the Connector Connector Gasket Equipment Monitoring Device (EMD) IP65 Connector 1 After removing EMD from cardboard sleeve, attach connector to the batterypowered node.
2 Tighten connector enough to slightly compress connector gasket. STEP 2 Installing the EMD Epoxy EMD to equipment housing with the Y axis perpendicular to rotating shaft. Connector Gasket INCORRECT Connector Gasket CORRECT 3 Be sure to note the node number for later use.
STEP 3 WWST Application Form Fill out the Waites Wireless Sensor Technology Application Form. STEP 4 Powering Up 1 Confirm that any EMD Connectors are correctly attached to the battery-powered node. Open lid of node. Waites Wireless Sensor Technology Application Form Node Connector # _____________________ Equipment ID _________________________ Location on Equipment (i.e. inboard beam, outboard bay, etc.
2 Place two (2) D size lithium batteries in battery carriage. Note orientation of battery so that the back of battery compresses carriage springs. 7 3 Immediately upon installation of 2nd battery, the blue LED on the front of battery-powered node will quickly give three (3) “blinks”. This means the unit is in standby mode and ready to be powered up.
4 Power up unit by firmly pressing and releasing blue LED button on the front of node. 5 The node will first perform a quality control test to ensure each EMD is correctly attached. This is communicated via six (6) blinks of the blue LED button. If the node detects a properly attached EMD at a particular node number (see p. 3 for reference), the blink is quicker than if the node does not detect a properly attached EMD.
FCC WARNING This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
IC Caution: Radio Standards Specification RSS-Gen, issue 5 IC Caution: RSS-Gen Issue 5 March 2019 "&" RSS-Gen numéro 5 mars 2019 - English: This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference.
