How-To Guide

28
OPERATING INSTRUCTIONS
Beforetheapplianceisusedforthersttimeitshouldbechargedfor16hours.
CHARGING THE RECHARGEABLE BATTERY
Connecttheplug-intransformertothepowersupply(g1).Ensuretheapplianceisswitched
off,otherwiseitcannotbecharged(g2b).
Place the appliance on the charging stand. Whilst charging the charging indicator will
illuminate.
The charger indicator will go out when removed from the charging stand.
We recommend you only charge your appliance when its performance has deteriorated
noticeably.
Longer charging times do not damage the appliance.
It takes approximately 16 hours for the appliance to be fully charged.
Use only the charging transformer supplied with this kit, DO NOT attempt to charge with any
other transformer.
OPERATION OF RECHARGEABLE BATTERY
UsingtheON/OFFswitch,switchontheappliance(g2a)Switchoffimmediatelyafteruse.
ATTACHMENT COMB
Yourapplianceissuppliedwithavariableattachmentcomb.Theattachmentcombhasve
settings. The further the attachment comb is pressed on to the appliance the shorter the
cuttinglength.Inthiswaythecuttinglengthcanbevariedbetween3-6mm(g3).
To attach the comb, attach on to the appliance in the direction of the arrow until it locks into
position(g4a).
Toremovepushthecombinthedirectionofthearrow(g4b)
CHANGING THE BLADE SET
The blade set can be removed by pushing the blade set away from the housing in the
directionofthearrowsee(g5a).
To replace blade set position it with the hook in the slot on the housing and press until it clicks
intoplace(g5b).
CLEANING AND MAINTENANCE
Never immerse the appliance in water.
Remove the attachment comb after each use and clean the blade set using the cleaning
brush.
Removethebladeset(g5)andcleantheblade,pressthecleaninglever(seeg6).This
allows you to remove any hairs and dirt between top and bottom blade with the cleaning
brush (easy cleaning).
The charging contacts of the appliance must be kept clean. Use only a slightly damp cloth for
cleaning the housing and charging stand never use solvents or scouring agents.
Oilthebladesetregularlyusingtheoilsupplied(g7)tomaintainthecuttingperformance
and ensure a long service life. Replace the attachment comb to protect the blade when not in
use.
The blade set should be replaced if cutting performance is reduced after extended use.
WIRING
WARNING:
This product must only be used with the transformer supplied,
Should a replacement be required contact Wahl customer services.