How-To Guide

25
Cleaning the Air Filter
Toensureagoodsupplyofairtothemotoritisessentialthattheairlteriscleanedregularly.
1. Removetheltercover(Fig.11a)andcleantheairlterwiththecleaningbrush.
2. Re-inserttheltercoveruntilitlocksintoposition(Fig.11b).
Cleaning the Blade Set
WARNING: The blade set must not be unscrewed
The blades must not be pushed apart and separated totally
• Remove the attachment comb (Fig. 5) after every use.
• Lift the blade set away from the clipper (Fig. 6).
• Use the cleaning brush to remove any cut hairs from the housing opening and from the blade set (Fig.
9).
• Push the top blade to the side (Fig. 9a) and removed any cut hairs from the top and bottom blade
using the cleaning brush.
• After cleaning return the top blade to its initial position (Fig. 9b). The top blade should be aligned in the
centre of the bottom blade.
• Aftercleaningwerecommendyouspraythebladesetwithhygienicspraytoushanydirtandhairs
through the blade and defend against bacteria and viruses.
• Wipeawayexcessuidthenoilthebladesetwithclipperoil(Fig.10).
• Only wipe the clipper with a soft, slightly damp cloth.
• Reattachthebladesetaftercleaning(Fig.7/8).Switchtheclipperonbrieytoensuretheoilisevenly
distributed.
note: For high performance, long lasting cutting performance, it is important to oil the blade set
frequently, at least before and after every use.
If the cutting performance deteriorates after long use despite regular cleaning and oiling, the blade set
should be replaced.
General Cleaning and Maintenance
Regular cleaning will ensure a long service life for your clipper.
Always disconnect from the power source prior to cleaning.
We recommend using the Hygienic Spray to degrease and clean blades.
Do not use solvents or scouring agents to clean any part of your clipper or blades.
Water based lubricating solutions should not be used to oil the blades.
Never operate your clippers without applying oil to the blades.
Repeated oil application should be carried out during the clipping process.
Always oil blades before storing the clipper.
We recommend that your clipper is stored in a dry area and blades are removed.
Wahlrecommendthatthisproductisservicedbyaqualiedtechnicianregularlytomaintainperformance
andefciency.(Manufacturercontactdetailsonbackpage)