How-To Guide

21
BATTERY REPLACEMENT, REMOVAL AND DISPOSAL
Battery Replacement
For battery replacement the entire, intact trimmer should be sent to: Wahl (UK) Ltd Customer Services
(theaddresscanbefoundonthereverseofthisbooklet)ortakentoasuitablyqualiedprofessional.The
battery should only be replaced by the original manufacturers spare.
Battery Removal and Disposal
At the end of its life, when it will no longer take a full charge, the battery in your clipper must be removed
andrecycled/disposedofcorrectly.Batteriesshouldbedisposedofatanofcialcollectionpoint.Ifyou
are having trouble removing the battery you can also return the product to Wahl (UK) Ltd Customer
Services, who will dispose of it in an environmentally safe way.
To remove the battery, follow these steps:
1. Unplug the transformer from the outlet, disconnect from the clipper and allow the batteries to
completely run down before disassembly.
2. Remove the blade.
3. Using a Torx 7 screwdriver, remove the 2 screws found under the blade.
4. Prizetheclipperhousingapartalongthejoinintheupperandlowercasing.
5. Remove the motor and PCB assembly.
6. Remove the battery by prizing up from the PCB (take care not to puncture the battery).
7. Apply tape to both ends of the battery before recycling/disposing.
WIRING
WARNING:
This product must only be used with the transformer supplied,
Should a replacement be required contact Wahl customer services.