Instruction Booklet

Lithium Ion Trimmer

may be longer than the others.

2. Attach the 6-position trimming guide to trim and

taper your beard. Begin with the guide set at a long

trimming length. Trim toward your chin in smooth,

overlapping strokes, following the lay of your beard.

If you trim against the way your beard naturally lays,

the trimmer will cut the hair much shorter than the

marked length.

Adjust the trimming guide to progressively shorter

settings until you reach the desired length of beard.

You may wish to set the trimming guide attachment

to cut closer near the ear and down under the chin,

changing to a longer setting toward the front of the

face and point of your chin. When the trimming

guide is removed, it will remain at its last length

setting until you change it.

Always be sure the trimming guide is locked solidly into the desired position

before you start to trim.

3. To cut the outline of your beard, remove the

trimming guide. Starting under your chin and

working back toward your jawbone and ears, cut

the outer perimeter of your beard underneath the

jawbone. Continue the line all the way up to the

ears and hairline.

4. Accentuate your beard line by using the trimmer in

a downward motion. Start at the line you’ve created

and, working from the chin back toward the ears, trim the area right under

your beard line.

5. Define the upper part of your beard using the same technique.

6. For a neater finished

look, replace

attachment blade

to the detail blade

forward. Use this

blade for fine, detail

trimming anywhere it is

needed, such as at the

sideburns near the ears, goatees, etc.

#1 Stubble Length (2 mm)

#2 Short (4 mm)

#3 Medium Short (6 mm)

#4 Medium (8 mm)

#5 Medium Long (10 mm)

#6 Long (12 mm)