Instruction Booklet

VACUUM TRIMMER

DO NOT USE SOLVENTS OR ABRASIVES!

For best results, put 5 drops of WAHL Clipper Oil on the blades only

when necessary, or approximately once a month. Motor bearings

are permanently lubricated—do not attempt to oil.

DO NOT OVER OIL!

Excessive oiling or application of liquids will cause damage if

allowed to seep back into motor.

CLEANING/STORAGE

To Clean Hair Collection Chamber: Holding the unit upright, press

thumb rmly on the bottom of the chamber and slide the collection

chamber out. With the hair chamber lid open, tip the chamber down,

and gently brush or rinse the trimmings from both the chamber

and the screen. Should the lter become detached, it can be easily

snapped back into place.

Be sure components are completely

dry before replacing in trimmer body.

(SEE H)

Alternate Method to Empty Hair

Collection Chamber: Pop open the

collection chamber door, and dump

trimmings into waste basket. Whisk

away any remaining trimmings with

cleaning brush.

Before storing your trimmer, use the

cleaning brush to whisk any loose

hairs from the unit and the blades.

Store unit in such a manner so that

blades are protected from damage.