Operating instructions

PROFESSIONAL SHAVER

CLEANING THE FLEX FOIL HEAD

Remove the ex foil head from the top

of the shaver by pressing the round

button located on the right side of

the shaver (g. C).

Next, lift the ex foil head o󰀨 of the shaver.

The ex foil head may be cleaned of loose

material, by gently tapping the housing against the surface of your

sink. Replace the ex foil head to the top of the shaver before use.

The foil is micro-thin with precise, raised inner cutting edges, always

handle with care.

CLEANING THE CUTTER BAR ASSEMBLY (g. D)

Remove the ex foil head from the top of the shaver by pressing the

round button located on the right side of the shaver. Next, lift the ex

foil head o󰀨 of the shaver; this will expose the cutter bar assembly.

Gently brush any loose hair and debris from the cutter bar assembly

and surrounding area by using the pre-shave brush. To remove the

cutter bar assembly, gently press down on it and turn the assembly

90 degrees. It should pop right o󰀨. Run the cutter bar assembly

under warm water and dry it o󰀨 with a paper towel. Return the

cutter bar assembly to the shaver by reversing this process and

replace the ex foil head.