Instruction Booklet

11
MAINS CLIPPER
1. Switch the appliance off using the on/off switch (Fig. 2 b ) and disconnect
from the power supply.
2. Undo the screws on the blade set; remove the bottom blade and the
top blade (Fig. 7).
When assembling, the bottom blade and the top blade should be aligned
as follows:
f Set the adjustment lever to the shortest cutting length (Fig. 4
a ).
3. Place the top blade on the plastic cam (Fig. 8).
4. Position bottom blade and re-insert the two screws.
5. Before tightening the screws, align the bottom blade (Fig. 9).
Warning! Injuries due to incorrect handling.
f Align the bottom blade so that there is a gap of 0.5 mm to
1.0 mm between the front edge of the bottom blade and the
front edge of the top blade (Fig. 9)
f Baldfader clipper can be aligned as close as 0.2mm.
6. Tighten screws (Fig. 7).
CARE AND CLEANING
Danger! Electric shock due to penetration of liquid.
f Switch the appliance off and disconnect from the power supply,
before you start with cleaning and care.
f Do not immerse the appliance in water!
f Do not allow any liquid to get inside the appliance.
f Only reconnect the appliance to the power supply if it is
completely dry.
Handle with care! Danger from aggressive chemicals.
Aggressive chemicals could damage the appliance and
accessories.
f Never use solvents or scouring agents.
f Only use cleaning agents and blade set oil recommended by
the manufacturer.
Hygienic spray and blade set oil are available from your dealer or
our Service Centre.