Instruction Booklet

16
SHAVER
OILING THE FOILS & CUTTER BAR
Oil lubrication helps maintain smooth blade movement and
shaving performance. If the shaver is regularly cleaned
under water. The Foils should be oiled at least once per
week. Use clipper oil or shaver oil.
Instructions: When foils and blades are clean and dry,
apply a drop of oil to the top of each foil and on top of the
center cutter bar. Use nger to gently spread the oil over
the surface. Turn the shaver on for 10 seconds to help
distribute the oil onto the blades below. Turn o󰀨 shaver and
use a tissue or soft cloth to wipe any excess oil from the
surface.
CLEANING & OILING TRIMMER BLADES
Clean with the included brush. For best results, put one or
two drops of blade oil on the blades only when necessary,
or approximately once a month.
Motor bearings are permanently lubricated—do not attempt
to oil. When oiling your shaver, turn the shaver “ON - I,” hold
the unit with the blades facing DOWN and squeeze one or
two drops of oil onto the blades. Wipe o󰀨 excess oil with
soft cloth.
Blade oil can be purchased from Wahl customer services.
NOTE: DO NOT OVER OIL!
Excessive oiling or application of liquids will cause
damage if allowed to seep back into motor.
FOIL & BLADE CARE
Trimmer blades have precision-hardened, ground and
lapped cutting teeth. Foils, cutter bar, and blades should be
handled carefully and never bumped or used to cut dirty or
abrasive material.