Instruction Booklet
12
HOT & COLD MASSAGER
DEEP HEAT ATTACHMENT
1. To insert deep heat attachment, simply align the
special track bar with the grooved section in the
massager stem, then press rmly onto stem. To
detach, use thumb and two ngers and pull away.
When the deep heat attachment is correctly inserted,
the heat element is automatically connected.
2. If using the massager for the rst time, begin with the
lowest heat setting. Test the surface for a comfortable
temperature. The massager will heat to the desired
level within four minutes.
NOTE: When using heat, always check temperature
before placing massager against skin. Everyone reacts
dierently to certain temperatures.
We suggest the following before use — check
temperature by lightly touching with ngertips the
silver heat plate on the massager. If uncomfortable
to your touch, reduce temperature by (1) rubbing
massaging surface onto a soft cloth, (2) moving the
HEAT button to a lower setting, or (3) turning o unit
for a short period before applying to your skin. Keep
the massager moving constantly when the heat is on.
3. Never use heat on swollen or inamed areas, or on
skin eruptions.
NEVER use the heat applicator if the plastic housing is
cracked or broken, or if the metal plate is loose, bent
or lifted.
CAUTION: The two holes in the stem of the massager
are like an electrical plug — electrical power is
transmitted through them
NEVER allow water near the stem, and never insert
anything into the holes.