Instruction manual

16
TP298
The cutting blade is provided with two longer guiding pins on the rear. Make sure that these pins are
seated in the bores of the printer enclosure. Then press the whole unit - possibly without jamming -
with some slight pressure. Finally, hand-tighten the thumb screw on the knife front side.
5.7. Printer configuration
During the printer configuration, you may set a number of parameters, in order to configure your
printer for the actual application situation. The internal parameters for regional, device, print,
interface and security settings are factory-set to satisfy the requirements of WAGO products.
Changes, as they are required for the processing of different print jobs, can usually be realized by
adjusting software settings.
6. Printer preparation
6.1. Insertion of the appropriate roller
The thermal transfer printer is supplied as standard with the roller suitable for inscribing the WMB
Inline. You may also print marking strips for the series TOPJOB
®
S and for series 870 etc., using this
roller.
A print roller for label printing is also supplied. The print roller for WMB Inline is not suitable for label
printing, due to its profile.
The roller exchange is very simple. Loosen the three screws on the side cover plate, using the tool
supplied.