Technical data

12 •
••
• The WAGO-I/O-SYSTEM 750
Storage, Assembly and Transport
WAGO-I/O-SYSTEM 750
ETHERNET TCP/IP
2.4 Storage, Assembly and Transport
Wherever possible, the components are to be stored in their original
packaging. Likewise, the original packaging provides optimal protection
during transport.
When assembling or repacking the components, the contacts must not be
soiled or damaged. The components must be stored and transported in
appropriate containers/packaging. Thereby, the ESD information is to be
regarded.
Statically shielded transport bags with metal coatings are to be used for the
transport of open components for which soiling with amine, amide and
silicone has been ruled out, e.g. 3M 1900E.
2.5 Mechanical Setup
2.5.1 Installation Position
Along with horizontal and vertical installation, all other installation positions
are allowed.
Attention
In the case of vertical assembly, an end stop has to be mounted as an
additional safeguard against slipping.
WAGO item 249-117 End stop for DIN 35 rail, 10 mm wide
2.5.2 Total Expansion
The maximum total expansion of a node is calculated as follows:
Quantity Width Components
1 51 mm coupler / controller
64 12 mm bus modules
- inputs / outputs
- power supply modules
- etc.
1 12 mm end module
sum 831 mm
Warning
The maximal total expansion of a node must not exceed 831 mm