Datasheet

 759-302 1
WAGO-I/O-CHECK 2 is a Windows application for
the checking of inputs and outputs and the display of a
WAGO-I/O-SYSTEM 750 node. The software is easy to
handle and it is not necessary to connect the node to a
fieldbus system.
The software reads out the node configuration and dis-
plays it as a graphic on the screen. This graphic can be
printed out along with a configuration list. Together they
are a complete node documentation.
With WAGO-I/O-CHECK 2 it is possible to display and
determine the process data of the bus modules. The
field wiring, including all sensors and actuators, can
thus be checked before start-up.
Application specific settings such as baud rate or sensor
type are possible for some particular interface, RTD and
thermocouple modules.
The communication between WAGO-I/O-CHECK 2
and the node is made via the communication cable
(included with delivery) which is connected between the
coupler and the serial interface port of the PC.
System requirements:
PC 486 /100 MHz or higher
recommended: Pentium
Operating system Microsoft
®
Windows
®
95 or higher
Microsoft
®
Windows NT
®
4.0
RAM memory 16 MByte minimum (Windows 95)
32 MByte minimum (Windows NT)
Hard disk storage 10 MByte minimum
CD-ROM
Graphics card VGA or higher;
recommended: SVGA
Graphics resolution 640 x 480 to 1024 x 768; 256 colors
Mouse required
Included: CD-ROM with software and documentation
Communication cable
Windows
®
is a registered trademark of Microsoft Corporation
WAGO-I/O-CHECK2
Start-upanddiagnostictoolfortheWAGO-I/O-SYSTEM750
WAGO-I/O-CHECK2
Description

Item-No. Pack.-unit
  pcs
TechnicalData
Subject to design changes WAGOKontakttechnikGmbH&Co.KG Postfach 2880 • D-32385 Minden Tel.: [phone] E-Mail: [e-mail]
31.07.2006 Hansastr. 27 • D-32423 Minden Fax.: [phone] www.wago.com