Datasheet

Subject to design changes WAGO Kontakttechnik GmbH & Co. KG Postfach 2880 •D-32385 Minden Tel.: [phone] E-Mail: [e-mail]
10.09.2008 Hansastr. 27 •D-32423 Minden Fax: [phone] www.wago.com
WAGO Communication Cable
The WAGO communication cable offers a simple solution for communicating
with the WAGO software tools (e.g., WAGO-I/O-CHECK 2,
WAGO-I/O-PRO)
NOTICE: The communication cable must not be connected or removed
when the system is energized.
The WAGO USB Service Cable connects a PC (notebook) to either the
service Interface of the 857 Series Signal Conditioners and Relay Modules
(JUMPFLEX) or to WAGO-I/O-SYSTEM buscouplers/controllers.
Notice:
Using the WAGO 759-923 USB Service Cable in combination with some of
the programmable fieldbus controllers requires a certain firmware version or
higher:
750-841 as from firmware version 12
750-872/0020-0000 as from firmware version 2
Description
Item no.
Pack.
unit
Communication cable 750-920 1
Technical Data
Connection 4-pole service connectors
Operating temperature 0 °C ... +55 °C
Degree of protection IP20
Length 2.5 m
Connector dimensions (WxHxD) 15 x 50 x 19 mm
Description
Item no.
Pack.
unit
WAGO USB Service Cable 750-923 1
Technical Data
USB specification 2.0 compatible/full-speed device
Operating system Windows 98/2000/XP/VISTA
Operating temperature -25 °C ... +70 °C
Interface USB type A/m
Length 2.5 m
Connector dimensions (WxHxD) 15 x 50 x 19 mm
Test voltage 2.5 kV, 50 Hz, 1 min.
Conformity marking 1
Immunity to interference acc. to EN 61000-4-3, EN 61000-4-6
Emission of interference acc. to EN 55022