Technical data
Table Of Contents
- 1 Important Notes
- 2 I/O Modules
- 3 Use in Hazardous Environments
- 3.1 Marking Configuration Examples
- 3.2 Installation Regulations
- 3.2.1 Special Conditions for Safe Operation of the ATEX and IEC Ex (acc. DEMKO 08 ATEX 142851X and IECEx PTB 07.0064)
- 3.2.2 Special conditions for safe use (ATEX Certificate TÜV 07 ATEX 554086 X)
- 3.2.3 Special conditions for safe use (IEC-Ex Certificate TUN 09.0001 X)
- 3.2.4 Special conditions for safe use (ATEX Certificate DEKRA 11ATEX0203 X)
- 3.2.5 ANSI/ISA 12.12.01
6 • Content
Standards and Guidelines for Operating the 750 Series
WAGO-I/O-SYSTEM 750
I/O Modules
1.2 Standards and Guidelines for Operating the 750 Series
Please adhere to the standards and guidelines required for the use of your
system:
The data and power lines shall be connected and installed in compliance
with the standards required to avoid failures on your system and to
substantially minimize any imminently hazardous situations resulting in
personal injury.
For assembly, start-up, maintenance and troubleshooting, adhere to the
specific accident prevention provisions which apply to your system (e.g.
BGV A 3, "Electrical Installations and Equipment").
Emergency stop functions and equipment shall not be made ineffective.
See relevant standards (e.g. DIN EN 418).
The equipment of your system shall be conform to EMC guidelines so that
any electromagnetic interferences will be eliminated.
Operating 750 Series components in home applications without further
measures is permitted only if they meet the emission limits (emissions of
interference) in compliance with EN 61000-6-3. You will find the detailed
information in section "WAGO-I/O-SYSTEM 750" "System
Description" "Technical Data".
Please observe the safety precautions against electrostatic discharge in
accordance with DIN EN 61340-5-1/-3. When handling the modules,
please ensure that environmental factors (persons, working place and
packaging) are well grounded.
The valid standards and guidelines applicable for the installation of switch
cabinets shall be adhered to.