Technical data
Table Of Contents
- 1 Important Notes
- 2 I/O Modules
- 3 Use in Hazardous Environments
- 3.1 Marking Configuration Examples
- 3.2 Installation Regulations
- 3.2.1 Special Conditions for Safe Operation of the ATEX and IEC Ex (acc. DEMKO 08 ATEX 142851X and IECEx PTB 07.0064)
- 3.2.2 Special conditions for safe use (ATEX Certificate TÜV 07 ATEX 554086 X)
- 3.2.3 Special conditions for safe use (IEC-Ex Certificate TUN 09.0001 X)
- 3.2.4 Special conditions for safe use (ATEX Certificate DEKRA 11ATEX0203 X)
- 3.2.5 ANSI/ISA 12.12.01
Important Notes • 5
Legal Bases
WAGO-I/O-SYSTEM 750
I/O Modules
All responsible persons have to familiarize themselves with the underlying
legal standards to be applied. WAGO Kontakttechnik GmbH & Co. KG does
not assume any liability whatsoever resulting from improper handling and
damage incurred to both WAGO´s own and third-party products by
disregarding detailed information in this Manual.
1.1.3 Use of the 750 Series in Compliance with Underlying
Provisions
Couplers, controllers and I/O modules found in the modular WAGO-I/O-
SYSTEM 750 receive digital and analog signals from sensors and transmit
them to the actuators or higher-level control systems. Using programmable
controllers, the signals can also be (pre-)processed.
The components have been developed for use in an environment that meets
the IP20 protection class criteria. Protection against finger injury and solid
impurities up to 12.5 mm diameter is assured; protection against water damage
is not ensured. Unless otherwise specified, operation of the components in wet
and dusty environments is prohibited.
1.1.4 Technical Condition of Specified Devices
The components to be supplied Ex Works, are equipped with hardware and
software configurations, which meet the individual application requirements.
Changes in hardware, software and firmware are permitted exclusively within
the framework of the various alternatives that are documented in the specific
manuals. WAGO Kontakttechnik GmbH & Co. KG will be exempted from
any liability in case of changes in hardware or software as well as to non-
compliant usage of components.
Please send your request for modified and new hardware or software
configurations directly to WAGO Kontakttechnik GmbH & Co. KG.