Technical data

12 • 750-630 (/xxx-xxx) [SSI Transmitter Interface]
Description
WAGO-I/O-SYSTEM 750
I/O Modules
2.1.1.3 Description
This module is an SSI interface for the direct connection to an SSI transmitter.
The power supply for the transmitter is derived internally from the power
jumper contacts.
After the interface has given a clock pulse to the sensor, the interface reads the
incoming data and transmits it directly in the form of a data word into the
process image of the PLC or PC. It is possible to factory adjust different
operating modes, transfer frequencies and data widths by means of the control
register.
The operational readiness of the module is indicated via a green function
LED.
Any configuration of the specialty modules is possible when designing the
fieldbus node. Grouping of module types is not necessary.
The field side supply voltage of 24 V for the output module is derived from
adjacent I/O modules or from a supply module. The supply voltage for the
field side is made automatically through the individual I/O modules by means
of power jumper contacts.
Attention
The module has no power jumper contact for receiving and transmitting the
ground (earth) potential. A supply module is required, if the adjacent
modules need to be connected to the earth.
Warning
The maximum current of the internal power jumper contacts is 10 A. When
configuring the system it is important not to exceed the maximum/sum
current. However, if such a case should occur, another supply module must
be added.
The module 750-630 and its variations can be used with all
couplers/controllers of the WAGO-I/O-SYSTEM 750 (except for the economy
types 750-320, -323, -324 and -327).
This description is valid from hardware and software version XXXX3A05...
and up. The version is specified in the manufacturing number, which is part of
the lateral marking on the module.