operation manual

D
51
W 950 Flexio
Varnish paints and glazes
GB
51
W 950 Flexio
22. Setting the  ow rate for the spray attachment ( g. 22).
Set the material volume by turning the regulator
on the trigger of the spray gun.
lower material volume

turn anti-clockwise
(-)
higher material volume

turn clockwise (+)
23. Spraying technique when using the spray attachment
i
The spray result depends heavily on the smoothness and cleanliness of the
surface to be sprayed. Therefore the surface should be carefully prepared and
kept free of dust.
•
Cover all surfaces not to be sprayed.
•
Cover screw threads or similar parts of the target object.
i
Important: Start at the edge of the area to be sprayed. Start the spray
movement  rst of all, and then press the trigger. Avoid interruptions
within the area to be sprayed.
•
The spray movement should come from the
arm, not just from the wrist. This ensures that
a uniform distance is maintained between the
spray gun and the spray surface during the
spray operation. Select a distance of 5 - 15 cm,
depending on the desired spray jet width.
Fig. 23 A: CORRECT: Even distance to
the object.
Fig. 23 B: INCORRECT: An uneven
distance will result in uneven
paint application.
•
Move the spray gun evenly cross-wise or up-and-
down, depending on the spray pattern setting.
•
An even movement of the spray gun results in an
even surface quality.
A
B