operation manual

GB
29
W 890 Flexio
i
For easier coating of ceilings and lying objects, we recommend the 60 cm
Universal Extra Extension. (Order no. 2361756)
6.
Place the container on a paper base and ll in the prepared coating material.
Screw the container rmly onto the spray attachment.
7. Connect the front part of the gun and the gun handle to each other. (Fig. 6)
8. Close the device cover and pull the carry handle upwards. This makes the gun holder
accessible.
9. Put the spray gun onto the gun holder at the device.
10. Place the device only on a plane and clean surface. Otherwise, the gun may suck in
dust, etc.
11. Switch on the main switch at the device (Fig. 1, item 14).
12. Remove the spray gun from the gun holder and point it at the object to be coated.
13. Press the On/O switch at the gun handle (Fig. 7, item 2).
i
The enclosed practice poster is ideal for familiarising yourself with
operation of the spray gun. After trying out the rst spray coatings, it
makes sense to test it further on cardboard or a similar surface in order
to nd out the right ow rate of paint and air for the best spray pattern.
Detailed information about these settings can be found in chapter
11-14.
11. Selecting the Spray Setting
(Standard spray attachment)
WARNING! Danger of injury! Never pull the trigger guard while adjusting
the air cap.
With the union nut (g. 8, 1) slightly unscrewed, turn the air cap (2) to the desired
spraysetting position (arrow). Then tighten the union nut.
Fig. 9 A = horizontal at jet  for horizontal surfaces
Fig. 9 B = vertical at jet  for vertical surfaces
Fig. 9 C = circular jet  for corners, edges and hard-to-reach surfaces