operation manual
EN
16
W14/W15/W16
Environmental protection
The tool and all accessories and packaging have to be recycled in an
environmentally friendly manner. Do not dispose of the tool with household
waste. Support environmental protection by taking the tool to a local
collection point or obtain information from a specialist retailer.
Leftover paint and solvents may shall be emptied into drains, the sewage
system or disposed of as household rubbish. It has to be disposed of
separately as special waste. Please pay special attention to the instructions
on the product packaging.
Important Note regarding Product Liability!
In accordance with an EC directive, the manufacturer is liable for his product only
if all parts originate from or were approved by the manufacturer and the tools are
assembled and operated correctly. The use of other accessories and spare parts can
partially or completely invalidate the liability.
WARNING UK ONLY
Your unit has been supplied with a supply cord and
a tted plug. This is identied by the fuse holder in
the base of the plug. Please read the following safety
instructions before use.
1. If the tted plug is cut o from the supply cord then
the plug must be disposed of safely. NEVER under
any circumstances insert such a plug into a 13 Amp
socket-outlet.
2. NEVER under any circumstances use the appliance or supply cord without the fuse cover
tted. This is the little cover xed into the base of plug to hold the fuse in place.
3. If you lose the fuse cover then please contact any electrical dealer for a replacement or
ring our helpline above.
4. A replacement fuse must be rated at 13 Amps and approved to BS1362.
5. IF IN ANY DOUBT PLEASE CONSULT A QUALIFIED ELECTRICIAN.
If you need to t a plug to the supply cord, this should be tted in accordance with the
wiring instructions below, and will need to be used with a 13 Amp fuse. If in doubt consult a
qualied electrician.
WARNING - THlS APPLIANCE MUST BE EARTHED. If you are using an extension lead it must
be rated a minimum of 10 Amps and fully unwound. Do not operate with a cord rated less
than 10 Amps as this will cause premature failure of the element which is not covered by
the guarantee. As the colours of the wires in the supply cord of this appliance may not