operation manual

GB
25
W 150
16. Accessories
The CLICK&PAINT SYSTEM with additional spray attachments and accessories oers
the right tool for each work.
i
We recommend against using the W 150 with the Wall Extra I-Spray
spray attachment.
Further information about the WAGNER range of products for renovating is
available under www.wagner-group.com
17. Correction of Malfunctions
Problem Cause Remedy
No coating
material
emerges from
the nozzle
•
Nozzle clogged
•
Feed tube clogged
•
Material volume setting turned
too far to the left (-)
•
Feed tube loose
•
No pressure build-up in container
➞ Clean
➞ Clean
➞ Turn to the right (+)
Insert
➞ Tighten container
Coating
material drips
from the nozzle
•
Nozzle loose
•
Nozzle worn
•
Nozzle seal is missing or worn
•
Coating material assembly at air
cap, nozzle or needle
➞ Tighten
➞ Change
➞ Insert an intact nozzle seal
➞ Clean
Atomisation too
coarse
•
Viscosity of coating material too
high
•
Material volume too large
Material volume adjusting screw
turned too far to the right (+)
•
Nozzle contaminated
•
Air lter heavily soiled
•
Too little pressure build-up in
container
➞ Thin
➞ Turn material volume
adjusting screw to the
left (-)
➞ Clean
➞ Change
➞ Tighten container
Spray jet
pulsates
•
Coating material in container
running out
•
Air lter heavily soiled
•
Nozzle seal is missing or worn
➞ Rell
➞ Change
➞ Insert an intact nozzle seal
Coating
material causes
"paint tears"
•
Too much coating material
applied.
➞ Turn material volume
adjusting screw to the
left (-)