User guide

3
English
1. Filling the
main tube
Start
Before filling:
Your TurboRoll™ can be used with two types
of container lids that are used to allow you to
pull material from the material container into the
TurboRoll™.
The lid below is desiged for use with standard,
one-gallon, round material containers. This lid
comes standard with your TurboRoll™.
Use the lid shown below if you are using
something other than a standard, one-gallon,
round material container. *Not included with
all models.
Attaching the container lid / fill tube
Filling the main tube
1. Apply a thin layer of
petroleum jelly to the ll
tube. This will help the ll
valve slide easily off the ll
tube.
1. Slide the small end of the ll tube
(a) through the hole in the container
lid you plan to use.
2. Press down and rmly hold the ll
valve onto the ll tube.
3. Make sure lever is switched to POWER (b).
Push the lower part of the switch (c) to draw
the plunger out and ll the tube. When the
tube is full, you are ready to begin rolling.
2a. Standard containers - Attach the
container lid with ll tube securely
to the material container.
2b. All other containers - Thread the
container lid with ll tube onto the
material container.
(a)
(a)
1
OR
1
(b)
(c)
2
2 3