operation manual

Standard spray attachment

Aligning suction tube

If the suction tube is positioned correctly, the container contents can be sprayed

without almost any residue.

When spraying horizontal surfaces, turn suction tube forward. (Fig. 2, A)

When spraying objects overhead, turn suction tube back. (Fig. 2, B)

Adjusting the material quantity (g. 3)

Set the material volume by turning the regulator on the trigger guard of the spray gun.

lower material volume  turn anti-clockwise (-)

higher material volume  turn clockwise (+)

Selecting the spray setting

WARNING! Danger of injury! Never pull the trigger guard while adjusting

the air cap.

With the union nut (g. 4, 6) slightly unscrewed, turn the air cap (5) to the desired

spraysetting position (arrow). Then tighten the union nut.

Fig. 5 A = vertical at jet



for horizontal surfaces

Fig. 5 B = horizontal at jet



for vertical surfaces

Fig. 5 C = circular jet



for corners, edges and hard-to-reach surfaces

Interruption of Work

When processing 2-component varnishes, clean the device immediately.

Shutting down and cleaning

1) Switch the unit o. Vent the container in case of longer breaks and after the work has

been terminated. This can be done by briey turning open and then closing the container

or by pulling the trigger guard and letting the paint into the original paint container.

2) Screw of the container and empty it. Pull out the suction tube with container seal.

Preclean the container and feed tube with a brush. Clean the ventilating bore

(Fig. 1, C).

Pour water or solvent into the container.

Do not use ammable materials for cleaning purposes.

5) Screw the container tightly onto the spray gun.

6) Spray the water or solvent into a container or a cloth.

Repeat the above procedure until the water or solvent emerging from the nozzle is clear.

8) Turn o the machine and remove the plug.

CAUTION! Never clean seals, diaphragm and nozzle or air holes of the spray gun

with metal objects. The ventilation hose and diaphragm are only solvent-resistant

to a limited extent. Do not immerse in solvent, only wipe.