operation manual

GB
8
Standard spray attachment
9) Pull the ventilating hose (Fig. 1 A, 12) at the top from the gun body. Screw o the valve
cover (13). Remove the diaphragm (14). Clean all the parts carefully.
10) Unscrew the union nut and remove the air cap and nozzle. Clean the air cap, nozzle
seal and nozzle with a brush and solvent or water.
Assembly
The unit may only be operated with an integer diaphragm (Fig. 1A, 14).
1)
Place the diaphragm (Fig. 1A, 14) with the pin facing upwards on the bottom section
of the valve. Also see the marking on the gun body.
2) Place on the valve cover (Fig. 1A, 13) and screw it closed.
3) Place the ventilating hose (Fig. 1A, 12) on the valve cover and on the nipple at the
gun body.
4) Push the nozzle seal (Fig. 1B, 3) over the needle (2); the groove (slot) should point
towards you.
5) Put the nozzle (Fig. 1B, 4) onto the gun body and nd the correct position by turning it.
6) Put the air cap (Fig. 1, 5) onto the nozzle (4) and tighten it using the union nut (6).
7) Place the container seal from below on the suction tube and slide it over the collar,
while turning the container seal slightly.
8) Insert the suction tube with container seal in the gun body.
Spare Parts List (Fig. 1)
Pos. Designation Order No.
3 Nozzle seal 0417 706
4 Nozzle (2.5 mm) 2362 878
5 Air cap
Australia (AUS) version order no. in brackets
2362 877
AUS (2361 747)
6 Union nut 2362 873
9 Container seal 2323 039
10 Feed tube (no marking or R)*
Feed tube (marking AR)*
2362 876
2367 410
11 Container 800 ml with cover
Container (aluminium) 800 ml with cover
0413 909
0420 708
12,13,14 Ventilating hose, valve cover, diaphragm 2304 027
15 O-ring 2362 875
*
Before placing the order, please check the bottom of the inside
of your spray attachment to see if there is a marking there. Do
this by unscrewing the container and removing the container
seal.
B253AR