operation manual

GB
9
Corner&Reach spray attachment
3. Place the ventilating hose (Fig.1A, 15) on the valve cover and on the nipple at the gun
body.
4.
Push the nozzle seal (Fig. 1B, 4) over the needle (2); the groove (slot) should point
towards you.
5. Insert all the parts of the extension into each other and keep in the packaging (Fig. 1,
pos. 3, 5, 6, 9).
6. Place the container seal from below on the ascending tube and slide it over the collar,
while turning the container seal slightly.
7. Insert the ascending tube with container seal in the gun body.
Spare Parts List (Fig. 1+6)
Pos. Designation Order No.
3 Needle, front section 0417 919
4 Nozzle seal 0417 706
5/6 Paint/air pipe
Australia (AUS) version order no. in brackets
0417 920
AUS (0417 926)
8 Union nut 2362 873
9 Air cap 0417 363
12 Container seal 2323 039
13 Feed tube 2362 876
14 Container 600 ml with cover 0414 906
15,16,17 Ventilating hose, Valve cover, Diaphragm 2304 027
18 Viscosity test cup 0209 058
The CLICK&PAINT SYSTEM with additional spray attachments and accessories o ers
the right tool for each work.
Further information about the WAGNER range of products for renovating is available
under www.wagner-group.com
Environmental protection
The appliance and accessories should be recycled in an environmentally
friendly way. Do not dispose of the appliance with household waste. Support
environmental protection by taking the appliance to a local collection point or
obtain information from a specialist retailer.
Important Note regarding Product Liability!
Due to an EC ordinance in e ect since 01.01.1990, the manufacturer is liable for his
product only if all parts originate from or were approved by the manufacturer and the
devices are assembled and operated correctly. The use of other accessories and spare
parts can partially or completely invalidate the liability.