operation manual
GB
6
Corner&Reach spray attachment
Read the operating instructions carefully beforeusing the tool and observe the safety
instructions. Keep the operating instructions in a safe place. The safety instructions
for the basic unit apply to this Corner&Reach spray attachment.
General instructions
The Corner&Reach spray attachment was developed for applying water-soluble and low-
viscosity materials containing solvents.
The spray jet is deected by 25° at the end of the 22 cm nozzle extension. This allows
problem-free coating of narrow spaces or points that are dicult to reach.
CAUTION!
•
The units may only be used with a functional valve. If paints rises in the
ventilating hose (Fig. 1 A, item 15) do not operate the unit further!
Dismantle and clean the ventilating hose, valve and diaphragm and replace
the diaphragm if necessary.
•
Do not place the spray gun on the side.
•
Do not combine components from dierent spray attachments.
The parts could be damaged.
Description (Fig. 1+6)
1) Gun body 2) Needle holder
3) Needle 4) Nozzle seal
5) Paint tube 6) Air tube
7) Turning aid 8) Union nut
9) Air cap 10) Material quantity regulation
11) Trigger guard 12) Container seal
13) Feed tube 14) Container
15) Ventilating hose 16) Valve cover
17) Diaphragm 18) Viscosity test cup
Assembly (Fig. 1-4)
Clip the needle onto the needle holders from above. (Fig. 2 A+ B)
Carefully attach the paint tube followed by the air tube (Fig. 3), and secure with the union nut.
Attach the air ap to the air tube. The position of the arrows must correspond. (Fig. 4 A+ B)
Align the feed tube (see instructions for the basic unit)
Spray on the container contents until there is very little remaining.
For spraying work with objects lying down, turn the feed tube forwards.
For spraying work on objects above head height, turn the feed tube to the rear.
Adjusting the spraying direction (Fig. 5 )
The rotary aid on the air tube always points in the same direction in which the spray jet is
deected. To adjust the spraying direction, turn the air tube in the desired direction with
the union nut slightly undone. Then tighten the union nut again.