operation manual

GB
7
Brilliant spray attachment
Viscosity Table
Sprayed material
Runout Time in Seconds
Wood&Metal, Wall Universal
630 W
280 W 300 W 350 W
Thinner-soluble primers
25-30 30-40
30 - 45
40-60
Thinner-soluble varnishes
15-30 20-45
20 - 45
30-60
Water-soluble primers
25-30 30-40
30 - 45
40-60
Water-soluble varnishes
20-25 20-35
20 - 40
30-55
Wood preservatives, strippers, oils
undiluted
Disinfectants, plant protectants
undiluted
Automobile spray paint
20-25 20-35
20 - 40
30-55
Aligning suction tube (refer to the instructions of the basic device)
If the suction tube is positioned correctly, the container contents can be sprayed
without almost any residue.
When spraying horizontal surfaces, turn suction tube forward.
When spraying objects overhead, turn suction tube back.
Adjusting the material quantity
To prevent paint runs on the object, rst adjust the paint quantity by spraying onto a piece
of card or paper from the same spraying distance.
First turn the adjustment knob (Fig.1, Item 7) fully to the left (-) and then slowly increase
the material quantity to the desired amount by turning it to the right (+).
For further information on setting the spray pattern and the correct spraying
technique refer to the instructions of the basic device.
Interruption of Work
i
When processing 2-component varnishes, clean the device immediately.
Shutting down and cleaning
Please also refer to the instructions of the basic device.
1) Switch the unit o. Vent the container in case of longer breaks and after the work has
been terminated. This can be done by briey turning open and then closing the container
or by pulling the trigger guard and letting the paint into the original paint container.
2) Screw of the container and empty it. Pull out the suction tube with container seal.
3) Preclean the container and feed tube with a brush. Clean the ventilating bore
(Fig. 1 , C).