operation manual
GB
8
Brilliant spray attachment
CAUTION! Never clean seals, diaphragm and nozzle or air holes of the spray
gun with metal objects.
The ventilation hose and diaphragm are only solvent-resistant to a
limited extent. Do not immerse in solvent, only wipe.
4) Pull the ventilating hose (Fig. 1 A, 12) at the top from the gun body. Screw o the valve
cover (13). Remove the diaphragm (14). Clean all the parts carefully.
5)
Unscrew the union nut and remove the air cap and nozzle. Clean the air cap, nozzle
seal and nozzle with a brush and solvent or water.
Assembly
The unit may only be operated with an integer diaphragm (Fig. 1A, 14).
1)
Place the diaphragm (Fig. 1A, 14) with the pin facing upwards on the bottom section
of the valve. Also see the marking on the gun body.
2) Place on the valve cover (Fig. 1A, 13) and screw it closed.
3)
Place the ventilating hose (Fig. 1A, 12) on the valve cover and on the nipple at the
gun body.
4)
Push the nozzle seal (Fig. 1B, 3) over the needle (2); the groove (slot) should point
towards you.
5)
Put the nozzle (Fig. 1B, 4) onto the gun body and nd the correct position by turning it.
6) Put the air cap (Fig. 1, 5) onto the nozzle (4) and tighten it using the union nut (6).
7) Place the container seal from below on the suction tube and slide it over the collar,
while turning the container seal slightly.
8) Insert the suction tube with container seal in the gun body.
Spare Parts List (Fig. 1 )
Pos. Designation Order No.
3 Nozzle seal 0417 706
4 Nozzle 1,8mm 2362 929
5 Air cap
Australia (AUS) version order no. in brackets
2362 930
AUS (2361 750)
6 Union nut 2362 873
9 Container seal 2323 039
10 Feed tube 2362 876
11 Container 600 ml with cover 0414 906
12,13,14 Ventilating hose, Valve cover, Diaphragm 2304 027
15 O-ring 2362 875
16 Viscosity test cup 0209 058
The CLICK&PAINT SYSTEM with additional spray attachments and accessories oers
the right tool for each work.
Further information about the WAGNER range of products for renovating is available
under www.wagner-group.com