Technical data

Plast Coat 15

Using coating materials in sacks

• Pull sliding cover back about 15 cm.

• Place sack on the sliding cover in such a way that the top

faces the front end of the sliding cover.

• Cut sack open.

• Allow the coating material to ﬂow into the receptacle.

• Move sack mangle forwards over the sack by turning the

crank handle until the guide rollers reach the stop pins.

• To ease pressing – move sack mangle to frame of sack mang-

le with your left hand.

• Strip remaining coating material from sack opening with a

spatula..

9.3 CONTAINER SUCTION SYSTEM

• Turn off device at master switch.

• Pull out mains plug from the socket and ensure that it can-

not be plugged back in unintentionally.

• Unscrew the hexagon nuts (2) on the receptacle (1, Fig. 21),

remove washers.

• Remove receptacle.

• Attach container connection (3) to the base of the receptac-

le. Mount disks and secure with hexagon nuts (4).

• Connect suction hose (5) to container connection (3). Al-

ternatively, connect connecting bridge (6) to the container

connection (3) and connect suction hose to connecting

bridge.

• Fill suction hose with water and connect to the container.

• Turn on mortar spraying machine.

Note:

All connections must be sealed air tight so that a vacuum can

be produced.

Place a small amount of machine lubricant onto the rubber

seals of the connections in order to allow for the easy opening

and closing of the connectors.

10 PLACING OUT OF OPERATION AND

CLEANING

Do not spray the motor or control unit of

the mortar spraying machine with water

jet, highpressure or steam cleaning equip-

ment. Water could penetrate the machine

and cause a short-circuit.

PLACING OUT OF OPERATION AND CLEANING