Instruction Manual

English
9
Cleanup -
Cleaning the
spray gun
Start
Before you begin:
When cleaning, use the appropriate cleaning
solution (warm, soapy water for latex materials;
mineral spirits for oil-based materials)
IMPORTANT: Never clean nozzle or air holes in
the spray gun with sharp metal objects. Do not
use solvents or lubricants containing silicone.
Special cleanup instructions for use
with flammable solvents (must have
a flashpoint above 70ºF (21ºC):
 • Alwaysushspraygunoutside.
 • Areamustbefreeofammablevapors.
 • Cleaningareamustbewell-ventilated.
 • Donotsubmergeturbine!
1. Remove the air hose from the
rear of the spray gun handle.
Wipe the exterior of the cup and
gun until clean.
4. Remove the adjustment ring (a)
carefully from the connecting nut
(b). Loosen the connecting nut.
2. Unscrew the nut and remove the
air cap and nozzle.
5. Remove the parts as shown.
Clean all parts with a cleaning
brush and the appropriate
cleaning solution.
To reassemble, see the
instructions on the next page.
3. Remove the parts as shown.
Clean all parts with a cleaning
brush and the appropriate
cleaning solution.
Reassemble when clean* (see
“Cup Seal”, left).
6. Push the tab below the trigger,
twist and separate the spray gun
from the handle.
Clean the rear of the spray gun
(c) with the appropriate cleaning
solution. Use a thin layer of
petroleum jelly to lubricate the
O-ring (d).
* Cup seal
It is important that the cup seal inside the spray
gun be re-installed properly. Make sure the cup
side of the seal (the side with the groove) is facing
out towards the front of the spray gun.
Groove
(a)
(b)
1
4
2
5
(c)
(d)
3
6
Yellow Gun
White Gun